Free xml sitemap generator

Buildings and Renovations,Other,Plumbing

Build a Basic Grey Water Filter System- Part 1

12 Dec , 2014  

Drilling-holes-in-greywater-bucket The grey water filter system was hatched from a late night fix of a blocked, groundwater pipe. The main drain pipe, which has been in use for 30 years, was 3″ in diameter and made from PVC. It’s job was to move ground water from the front of the cabin (uphill) and empty to the back (downhill). Found out It was plugged up with dirt and ice from a cold snap. The plug had occurred at the section where the ABS greywater/sink pipe intersects with the PVC ground water pipe. Lucky for me, the 3″ PVC pipe was not cracked and the Y connector had just wiggled loose. The only set back was that the ABS drain pipe was firmly connected to the Y connector of the PVC pipe. It made it next to impossible to remove the Y connector, clean the joint and re-apply the PVC glue. So, I decided to re-root the ABS and plumb in a separate direction. The best bet was to run it parallel with the 3″ PVC, through the back wall, underground for 20 feet, to a small 5 gallon water bucket. The bucket would be filled with gravel and the soapy water would flow into it and slow disperse into the ground. The gravel should function as a basic filter system. In time, the plan is to upgrade this basic system. It was just something whipped up in a few hours and get us through the winter.

What is Greywater?
According to Wikipedia: Greywater or sullage is defined as wastewater generated from wash hand basins, showers and baths, which can be recycled on-site for uses such as toilet flushing, landscape irrigation and constructed wetlands. Greywater often includes discharge from laundry, dishwashers and kitchen sinks. It differs from the discharge of toilets which is designated sewage or blackwater to indicate it contains human waste. http://en.wikipedia.org/wiki/Greywater

Greywater-Filter-with-rocks Greywater-Filter!


Comments are closed.

%d bloggers like this: